APPLICATION: Synthetic Reinforcement Used in PP Door Trim
Milliken's Hyperform HPR-803i magnesium-based reinforcing fibers adds exterior door trim to its cache of automotive applications.
MillikenReinforcingFiberinCrossovervehicleexteriordoortrim)
Since its launch in 2009, Hyperform HPR-803i, a synthetic magnesium-based reinforcing fiber from Milliken Chemical Co., Spartanburg, S.C., has been used in PP compounds for auto interior components such as tailgates and B-pillar trim. Most recently, it was used by a European Tier I supplier for the exterior door trim of a new production crossover vehicle, demonstrating its aesthetic as well as lightweighting benefits. In this case, a density reduction of 8% was achieved for the part through the replacement of 20% talc with a combination of 8% talc and 3.5% HPR-803i.
Hyperform-reinforced PP compounds are now available from North American as well as European compounders, including Washington Penn Plastics, Washington, Pa., Noble Polymers, Grand Rapids, Mich., and Albis, Sugar Land, Texas. This reinforcing agent allows automotive designers to create parts that maintain properties with less filler than conventional materials, making them up to 15% lighter. Large injection molded PP parts can be produced with only 12% HPR-803i instead of 30% talc. PP compounds reinforced with this fiber are said to retain excellent stiffness/impact balance and HDT, even after multiple recycling and compounding operations. Improved surface appearance has also been shown, allowing processors to reduce pigment usage while meeting color requirements. Ditto for scratch resistance, allowing for further formulation optimization.
(800) 910-5592 • milliken.com
Related Content
-
Project Reveals Added Benefits of New P20 Grade Steel in Machinability, Cycle Time and No Stress Relief
MoldMaking Technology's Christina Fuges talks with General Motors' Shane Appel about a project testing a new P20 steel grade's dimensional stability.
-
Mold Builder Uses Counter-Intuitive Approach for Mold Challenges
Matrix Tool Inc. answers customers’ hard questions with creative solutions for cavity spacing, tool sizing, runner layout and melt delivery that reveal the benefits of running in a smaller press size at lower cavitation but higher yield.
-
Hot Runner Technologies Advance Quality Surface Requirements in Automotive
Oerlikon HRSflow hot runner systems combine cost-efficient production with a precise process control for a variety of automotive applications.