Inspection/Measurement

Exploring the: Inspection/Measurement Zone

103 Results for: Article

Sort by:
Published: 6/20/2011

Consumer Products:Demands for Thinner Walls/Lightweight Designs Challenging Moldmakers

Recently MoldMaking Technology magazine reached out to its Editorial Advisory Board to examine current trends in the consumer products market and how moldmakers are addressing the challenges.

Published: 4/1/2011

On-Machine Probing Technology for Mold Manufacture

Decision points to help you select the right probing system.

Published: 4/1/2011

How to Save Time and Money with Faster Measurements

Today’s mold manufacturer is often looking for time and cost savings on many levels. There are solutions—whether it is to reduce development times, accelerate the configuration of entire initial sample test reports or shorten reaction ti...

Published: 2/15/2011

BMW Achieves Faster Tooling/Part Inspection

Hardware-independent software for the inspection of prototypes, tooling and production samples against CAD data is being used on two Zett Mess AMPG measuring arms to inspect chassis prototypes at BMW.

Published: 2/15/2011

BMW Achieves Faster Tooling/Part Inspection

Hardware-independent software for the inspection of prototypes, tooling and production samples against CAD data is being used on two Zett Mess AMPG measuring arms to inspect chassis prototypes at BMW.

Published: 1/18/2011

Long Range Inspection Capabilities with Laser Scanner

Leica Geosystems ScanStaion C10 Laser Scanner.

Published: 1/18/2011

Computer-Aided Inspection and Reverse Engineering Software

Verisurf X software.

Published: 1/11/2011

Height Gages

Master Heightâ„¢ line.

Published: 1/11/2011

Measurement and Alignment

New Pinpoint Capture Expands Laser Microgage Uses.

Published: 1/6/2011

Inspection Software

New release of PowerINSPECT inspection software makes the analysis of results even easier with the introduction of a "Quick Report" option.