Gone Fishing!
Share your unusual application stories with us
Sherry L. Baranek
Senior Writer, MoldMaking Technology magazine
Share
Featured Content
Every month MMT publishes case studies both in print and online. As the author of many of these case studies, I am constantly fascinated at the success stories mold manufacturers share about the challenges they face, a new product or technology they discover to address a specific issue or challenge, and the myriad of benefits they realize once the solution is applied—whether it be leadtime reduction, money saved or quality improvements. It is an added bonus for me when an unusual application is highlighted. Case in point: Damon Weaver, president of Xcentric Mold & Design—a low-volume, short-run, complex custom mold specialist—used KeyCreator from Kubotek USA to produce a fishing rod holder efficiently. Read here about how Damon did it, and send me your unusual application stories!
We’d rather send you $15 than rely on our crystal ball…
It’s Capital Spending Survey season and the manufacturing industry is counting on you to participate! Odds are that you received our 5-minute Metalworking / Plastics survey from MoldMaking Technology in your mail or email. Fill it out and we’ll email you $15 to exchange for your choice of gift card or charitable donation. Are you in the U.S. and not sure you received the survey? Contact us to access it.
Help us inform the industry and everybody benefits.
RELATED CONTENT
-
Micro-Milling Opportunities and Challenges
An integrated approach to the design and machining of micro-milling components is key for mold manufacturers looking to capitalize on this growing opportunity.
-
Simplifying Mold Construction
How to solve your internal thread molding problems with the right core.
-
2013 Automotive Vendor Tooling Study
The results of this industry survey set the stage for suggested practices and strategies that could help the entire vendor tooling value stream be more competitive, have adequate capacity and reach its desired success.
