This list is a comprehensive collection of product announcements provided by companies. You may search for specific product information or browse to stay updated.

You are viewing products related to: Hot Runners

PUBLISHED: 9/13/2017

Hot Runner Cleaning System Uses Sand for a Safer, Less-Caustic Scrub

The Alliance Hot Runner Manifold Cleaning System applies high temperatures to sand to remove rubber, plastic and paint from steel parts.

PUBLISHED: 9/12/2017

Needle Valve System without Control Unit Meets Quality Requirements

The electronics of the HRSflow’s Flexflow One needle valve system shut down at the point of maximum torque to prevent hot runner and mold damage.

PUBLISHED: 9/11/2017

Two New Products: Velocity Control and Nozzle Design

The DF 12 nozzle has a MultiPower heater, which Incoe says is suitable for the manufacturing of components in the automotive industry. Incoe’s SoftGate valve pin velocity control enables users to set required valve-opening time.

PUBLISHED: 7/7/2017

Hot Runner Nozzles Designed for Thin-Wall and Thick-Wall Applications

HRSflow presents hot runner nozzles of the MTR range, designed for both thin-wall and thick-wall injection molding processes, from its Multitech line.

PUBLISHED: 6/5/2017

Flexible Tubular Heaters Can Be Bent by Hand

Türk + Hillinger offers its Flex flexible tubular heaters in 6.5-, 8- and 8.5-mm diameters, and 6.0- and 8.0-mm cross sections.

PUBLISHED: 5/31/2017

Hot Runner Enhancements Suited for Sequential Molding

Synventive will showcase design enhancements to its SVG+ hot runner systems for sequential molding of large parts.

PUBLISHED: 5/29/2017

Hot Runner Components Better Resist Abrasive Polymers

Mastip’s G5 tip and H5 nut combination is designed for improved resistance to abrasive polymers, resulting in reduced wear and tear, and therefore reduced downtime for replacement of the hot runner parts.

PUBLISHED: 5/26/2017

Slim Nozzles Allow for Tight Pitch Spacing

Incoe will present its slim DF 5 nozzle, which features a 5-mm flow channel and slim base heater.

PUBLISHED: 5/25/2017

Tunnel Gate Inserts Hide Gate Vestige

Tunnel gate inserts from i-mold GmbH are designed for bottom (submarine) gating in cases where the upper or visible surface of a molded part cannot show any gate vestige.

PUBLISHED: 5/25/2017

Servo-Driven Valve-Gate System Produces High-Quality Parts

HRSflow’s Flexflow One servo-driven valve-gate system does not require a separate control unit; the stroke, position and velocity of each hot runner nozzle valve pin can be programmed through a handheld programmable logic controller (PLC) or externa...

RSS RSS  |  Atom Atom