Rethinking Three-Axis Capabilities
Ballnose cutters don’t necessarily require five-axis machining routines to impart fine surface finishes that don’t require hand polishing.
A three-axis machine and ballnose cutter proved sufficient to achieve this part's 16-µm surface finish without hand polishing.
Moldmakers could be missing out on substantial time and cost savings by underestimating the capabilities of their three-axis machine tools. So says Jim Endsley, machining center product specialist at Okuma America Corporation. During a recent open house event at the company’s Charlotte, North Carolina Headquarters and nearby Partners in THINC facility, he used the 4140, pre-heat-treated steel die shown above to demonstrate the possibilities of cutting “straight down” with a ballnose end mill rather than at an angle.
Some machinists might conclude that the only way to produce the part’s 16-µm surface finish without costly, time-consuming hand polishing would be to use an additional axis of motion to approach the work at an angle of about 15 degrees. This ensures clean cutting action by preventing the ballnose tool’s rounded bottom from rubbing the material. However, Endsley says machine and cutting tool technology has advanced to the point that this might not be necessary. Specifically, he cites flank design enhancements and tool coatings that enable newer ballnose tools to perform effectively at the high cutting parameters typical of modern machine tool CNCs. Along with the draft angles typical to mold and die components, these features enable users to achieve the same results in only three axes by approaching straight-on, but at significantly higher feed rates and reduced stepovers.
“The trend in moldmaking is always to overcomplicate things,” Endsley notes. That’s worth considering next time you’re considering the need for hand polishing or tying up a valuable five-axis machine with work that might not actually require either. Meanwhile, take a look at this slideshow for more of what I saw at the open house, including various “smart” technology that makes machining easier and more efficient, performs tedious tasks automatically and behind the scenes, and customizes how users interact with their equipment, among other systems.
Related Content
-
3D Printing Enables Better Coolant Delivery in Milling Operations
Just like 3D printing enabled conformal cooling channels in molds, additive manufacturing is now being used to optimize coolant delivery in cutting tools.
-
The Benefits of Hand Scraping
Accuracy and flatness are two benefits of hand scraping that help improve machine loop stiffness, workpiece surface finish and component geometry.
-
Solving Mold Alignment Problems with the Right Alignment Lock
Correct alignment lock selection can reduce maintenance costs and molding downtime, as well as increase part quality over the mold’s entire life.